Easy to Build DIY Carbon Filter

H

Hdoc29

Member
:joint:

Thank you MightyBuddah for researching and posting that information. It was precise and informative. I know I'm a little over four years late to the forum. But, you have save me time and $ with your research! Thanks again!
 
D

Dorian Gray

Member
Wow very informative thank you ...Well I am new I like to learn about removing room odor.I under stand carbon filters help. Do I have to extract the air out of the room or can I circulate the air. I am not to worried about heat because I be using LEDs.What are some of the basic for removing room odor?
 
doowmd

doowmd

Well-Known Member
You want the air to be exchanged/extracted thru the room because the plants need fresh air to be healthy. Place an intake hole w/ a fan pulling air in the bottom of one end of the room for your intake, and place an output hole w a fan blowing out in the top of the other end of the room. Place the carbon filter described in this thread between the wall's "output hole" and the fan like shown in the first post:513_p5707.jpgView attachment 1776032

The reason to place the intake and out put holes at the bottom of one end and top the other, respectively, is because heat rises and cool air is dense and"sinks" so this set-up allows cool air to be sucked in and the hot air to be exhausted.
 
Saldaw

Saldaw

Well-Known Member
how strong does the fan have to be? im afraid that my fan wont push the air through the carbon
 
Min8040

Min8040

Well-Known Member
MightyBuddha thanks for sharing this with everyone. I will definetly be using this design once my room is complete. Nice and simple and easily customized to suit ones needs. +rep.
 
805Farming

805Farming

Active Member
Just so I can be clear, I need the air to come through the carbon filter, then be vented out of the grow area via attached fan, correct?
 
SFguy

SFguy

Well-Known Member
all of you, how big is the room you trying to scrub with this, i have a 6" vortex and 36" carbonfilter to do the job
 
C

crash1522

Member
MightyBuddha said:
I can't take credit for this it has been ripped from another site but it is worthy of posting. I built one about double the length of the one below and found it to be very effective. I also attached it directly to a bathroom fan unit so it is inside of the grow room not hooked to the exhaust.

**





Im sure this works well but roll of screen is about $8 filter is about $20 both ends are about $15 for end cap and reducer. and about $5 if you dont have duct tape already. if you can afford the $40-50 for this go the extra $20 and get a real one. HTGsupply.com has about cheapest ive seen.
Click to expand...
 
JayJayDaStoner

JayJayDaStoner

Active Member
another idea for you guys Ona bucket next level

Took ducting connected it to a booster fan to the top of the lid Ona liquid and soilmoist crystals and then made another hole
in the side and it vents perfectly cost me a total of 40$

ona swag.jpgona.jpg
 
You must log in or register to reply here.
Top