GYO Grow Tent.. Help please?

This is an absolutely HORRIBLE tent in my opinion. The dimensions are 5 feet tall x 3 feet wide x 20 inches deep. There are minor light leaks through the ventilation flaps and through the vent ducts. The mylar inside is decent. My problem is the fact that it has 3, 4inch duct holes. 1 on the bottom left side, 1 on the back top left side, and 1 on the cieling.. LEFT SIDE! How the hell are you supposed to air cool a light in a tent that all the damn vent ducts are on the same side? And where the hell are you supposed to route your wires?? If you don't get what I'm saying here...



The three rectangular vents on the bottom have a mesh over them so nothing goes through them except air, the 3 circular vents are for ducting and are all located on the left side. There is no holes to route your wires through so I routed them through the bottom left duct vent.. but now I have no place to put an intake fan.. fuck my life. I suppose I could do some modifications although I don't want to. Any ideas?? I paid $90 for this tent.. shipping included so it wasn't the most expensive but damn. Don't buy this.. go with HTG supply mother tent

I don't see the problem.

You don't need inlet fan, passive inlet will be fine.
For maximum control, cool your tubes with direct outside air. Duct air in from bottom hole >>>> through the tubes >>>>> duct out through top hole. No filter as air is clean. Secondary fan connected to filter pulling filtered air up and out through second upper hole. Open vent flaps at the bottom for clean air to come in.

Job done.

MrMeanGreen said:

I don't see the problem.

You don't need inlet fan, passive inlet will be fine.
For maximum control, cool your tubes with direct outside air. Duct air in from bottom hole >>>> through the tubes >>>>> duct out through top hole. No filter as air is clean. Secondary fan connected to filter pulling filtered air up and out through second upper hole. Open vent flaps at the bottom for clean air to come in.

Job done.

Click to expand...

This would just be a terribly awkward design. They should of put 2 duct vents on the bottom. 1 on left 1 on right and same up top that way I could have air cooled hood straight across along with an inlet fan on the bottom...

and this STILL doesn't solve where mah damn cords go! agh!

here. have some of this.

elenor.rigby said:

here. have some of this.

Click to expand...

mmm... ok

Hey bro, my cords come in from the top, I inlet with an inline 4 in inside my tent then pull exhaust from my lite out the top back.....

cords and a 4" ducting should fit in the hole. cords arent much ya know, and ducting is flexible