Help me clone properly

S. African grower · Dec 30, 2018

ANC said:
It is advisable to clone using the same type of media to root in as you plant to grow in as roots develop according to their environment.
This saves time reconfiguring.

Thanks, that's what I done.

raratt · Dec 30, 2018

https://www.growweedeasy.com/cloning-marijuana-guide

I followed this with great success. 100% rooted, but I guess it depends on the strain also.

myke · Dec 30, 2018

The real key here is having the mother plant healthy,low in N and has been foiler fed with cal mag and fulvic acid a few days prior to cutting.
All these articals you u read dont mention the most important part.Look up* cloning mothers*

raratt · Dec 30, 2018

myke said:
The real key here is having the mother plant healthy,low in N and has been foiler fed with cal mag and fulvic acid a few days prior to cutting.
All these articals you u read dont mention the most important part.Look up* cloning mothers*

I did none of that and they all rooted fine.

myke · Dec 30, 2018

raratt said:
I did none of that and they all rooted fine.

Good for you,some strains are easy. Some not so much. It is a good thing to know though. Having nice green heathy clones 10 days after cutting isn’t always easy.

Thegermling · Dec 30, 2018

I made a cheap 3 site bubble cloner from a food container and after the 7 day mark I started to see little nubs. At the 10 day mark this is what I got. I put some recharge in there as well but I seen some slime buildup. I plan on only using tap and a few drops of bleach to keep everything sterile.

myke · Dec 30, 2018

ya in my experience the bubble cloner is much easier,no need for domes or hardening off when rooted.

ANC · Dec 30, 2018

Get a bucket from the china shop.

TassieConvict · Dec 30, 2018

I normally just cut in a way to create as much surface area on the cut as possible, dip in rooting gel and place in a wet jiffy pellet. Ive got a seedling tray setup in a box under 2x cfl lights and the seedling tray sits between 20 - 25 degrees celcius. Good success rate and roots pop out of the jiffys in about 14 days.

DustBomb · Dec 30, 2018

It all works. 45 degrees cut, flat cut, clean or dirty sissors, using ur nail, rooting gel, no gel. Doesn't matter. always 10-14 days . Just make sure ur temps and humidity are where they're suppose to be and ur golden .

Lucky Luke · Dec 30, 2018

TassieConvict said:
I normally just cut in a way to create as much surface area on the cut as possible, dip in rooting gel and place in a wet jiffy pellet. Ive got a seedling tray setup in a box under 2x cfl lights and the seedling tray sits between 20 - 25 degrees celcius. Good success rate and roots pop out of the jiffys in about 14 days.

Same way I do it. I have a bubble cloner and don't use it anymore.

Help me clone properly

S. African grower

Well-Known Member

raratt

Well-Known Member

myke

Well-Known Member

raratt

Well-Known Member

myke

Well-Known Member

Thegermling

Well-Known Member

myke

Well-Known Member

ANC

Well-Known Member

TassieConvict

Active Member

DustBomb

Well-Known Member

Lucky Luke

Well-Known Member

Similar threads