2closetgrowers
Member
So last year I had my first 2 grows. I only grow for my wife and I so no need to go big so I grew in a closet we already had. I struggled with high temps since the room it was in has poor ventilation, lack of stealth due to loud noise from the blowers I bought by accident, and lack of stealth due to lack of odor control. However, I still managed to pull some great bud from it for my wife and I. Last year I grew Lowryder 2's, Northern Lights, Blue Hash, and Royal Kush and pulled more than enough for our limited smoking needs.
Over the past year I purchased things here and there to build the cab I thought would be a good next step. My goals were to have it be stealth, light proof, smell proof, safer, and quiet while cool. I think I've accomplished all of those goals with the cab I recently finished.
Before I explain what I have, please remember, I'm a newb at this, I'm not an accomplished builder, and while I'm open and appreciative of constructive feedback, lets keep things nice as I'm sharing to possibly help other newbs.
You'll notice I used lots of duct tape, thats because I don't have a lot of tools and I only used in places where I needed a bit of sealing up. I didn't use it for structural items. So here was my assembly method:
1. Created DIY Cool Tube based on plan found googling, google DIY Cool tube and your all set. I had a large 6 inch cool tube but this cab was far to small for it.
2. Created Screen for my Screen of Green by cutting out a large part of each side of the shelf and stapling in the chicken wire.
3. Drilled hooks to hold up Cool Tube, Carbon Filter, and Fan.
4. Used thick bungie cords to place carbon filter and fan up, used chain to place cool tube up.
5. Venting - Drilled lots of holes, 2 at very top of cab, 3 in panel of cab separating electrical area from gro area, 2 in back of electrical area, then three holes in bottom of cab. Air flow is separated into two distinct areas; grow and light. Air for my grow comes in the bottom, through carbon filter, up through top of cab into fan, then blown out very top of cab. Air for light tube comes from back of cab, through light tube then through fan and blown out of top. Both of these out vents are located near each other and have box on top to act as a muffler.
6. Used weather stripping to seal up all of grow portion of cab. Made wife get in to test if light proof
7. Drilled Small holes next to each of the vent holes to zip tie venting to cab then used duct tape to seal up gaps.
8. Connected all items and setup electrical at the top
9. Set up 2 automatic fire extinguishers, one in top, one in bottom, either will pop if temp gets above 155.
10. Ran test for light and temp. Temp never went over 81, light never got out.
Here will be my growing method and items:
1. Fox Farms Soil mixed with Perlite. 2/3rds FF Soil to 1/3 Perlite
2. Fox Farms Trio of Nutes following their directions and of course watching how plants react.
3. Water PH balanced each time I feed to whatever its supposed to be, can't remember right now but its on the bottle. I let my water sit for 24 hours as well.
4. Starting with 1 gallon pots then upgrading to 5 gallon pots for rest of grow.
5. Light is 250 HPS throughout entire grow, starting with 20/4 then switching to 12/12
6. Grow Area is as follows, Pots are 11.5 inches tall, then 8 inches to top of screen(worked for me last year), then at maximum height with 4 inches of clearance between light and plants it gives me 22 inches of growing room, 20 inches deep, and 28 1/2 inches wide.
7. Goal is to get 1/2-1 ounce from each plant. I'm more than happy with half from each as 2 grows a year gets my wife and I plenty of weed.
Growing 1 Feminized Green House Super Lemon Haze and 1 Feminized Dutch Passion BlueBerry. Seeds were germinated using just a cup of water each and letting sit for a few days. Both germinated. Planted in soil on 9/21 late at night. Today on 9/23 they both popped out of the soil. Will update about every 3 days and updates will be less wordy I'll also take better pix as I go, just not much to capture right now.
Over the past year I purchased things here and there to build the cab I thought would be a good next step. My goals were to have it be stealth, light proof, smell proof, safer, and quiet while cool. I think I've accomplished all of those goals with the cab I recently finished.
Before I explain what I have, please remember, I'm a newb at this, I'm not an accomplished builder, and while I'm open and appreciative of constructive feedback, lets keep things nice as I'm sharing to possibly help other newbs.
You'll notice I used lots of duct tape, thats because I don't have a lot of tools and I only used in places where I needed a bit of sealing up. I didn't use it for structural items. So here was my assembly method:
1. Created DIY Cool Tube based on plan found googling, google DIY Cool tube and your all set. I had a large 6 inch cool tube but this cab was far to small for it.
2. Created Screen for my Screen of Green by cutting out a large part of each side of the shelf and stapling in the chicken wire.
3. Drilled hooks to hold up Cool Tube, Carbon Filter, and Fan.
4. Used thick bungie cords to place carbon filter and fan up, used chain to place cool tube up.
5. Venting - Drilled lots of holes, 2 at very top of cab, 3 in panel of cab separating electrical area from gro area, 2 in back of electrical area, then three holes in bottom of cab. Air flow is separated into two distinct areas; grow and light. Air for my grow comes in the bottom, through carbon filter, up through top of cab into fan, then blown out very top of cab. Air for light tube comes from back of cab, through light tube then through fan and blown out of top. Both of these out vents are located near each other and have box on top to act as a muffler.
6. Used weather stripping to seal up all of grow portion of cab. Made wife get in to test if light proof
7. Drilled Small holes next to each of the vent holes to zip tie venting to cab then used duct tape to seal up gaps.
8. Connected all items and setup electrical at the top
9. Set up 2 automatic fire extinguishers, one in top, one in bottom, either will pop if temp gets above 155.
10. Ran test for light and temp. Temp never went over 81, light never got out.
Here will be my growing method and items:
1. Fox Farms Soil mixed with Perlite. 2/3rds FF Soil to 1/3 Perlite
2. Fox Farms Trio of Nutes following their directions and of course watching how plants react.
3. Water PH balanced each time I feed to whatever its supposed to be, can't remember right now but its on the bottle. I let my water sit for 24 hours as well.
4. Starting with 1 gallon pots then upgrading to 5 gallon pots for rest of grow.
5. Light is 250 HPS throughout entire grow, starting with 20/4 then switching to 12/12
6. Grow Area is as follows, Pots are 11.5 inches tall, then 8 inches to top of screen(worked for me last year), then at maximum height with 4 inches of clearance between light and plants it gives me 22 inches of growing room, 20 inches deep, and 28 1/2 inches wide.
7. Goal is to get 1/2-1 ounce from each plant. I'm more than happy with half from each as 2 grows a year gets my wife and I plenty of weed.
Growing 1 Feminized Green House Super Lemon Haze and 1 Feminized Dutch Passion BlueBerry. Seeds were germinated using just a cup of water each and letting sit for a few days. Both germinated. Planted in soil on 9/21 late at night. Today on 9/23 they both popped out of the soil. Will update about every 3 days and updates will be less wordy I'll also take better pix as I go, just not much to capture right now.
Attachments
-
59.4 KB Views: 46
-
32.3 KB Views: 28
-
32.1 KB Views: 35
-
27.7 KB Views: 24
-
38.9 KB Views: 30
-
49.4 KB Views: 40
-
29.1 KB Views: 52
-
66.2 KB Views: 25
-
55.9 KB Views: 34
-
90.6 KB Views: 30
-
37.7 KB Views: 88
-
44.9 KB Views: 40
-
46.1 KB Views: 37
-
51.8 KB Views: 44
-
64.4 KB Views: 58