HGK420
Well-Known Member
Anyone else experiencing a similar issue or if you just have a power cloner in general I got a little tip that might save you some of the panic I just felt.
Full cloner. 18 plants with only a week to go. I was already adding up how much it would set me back to re clone a new batch when an idea hit.
Idea number 1. Get a length of black tubing or whatever you got laying around hoselike and use it to massively blow air into your cloner Rez causing it to bubble furiously and in turn wetting your cuttings.
Idea 2. This is the one I implemented. I'm lucky enough to be on city water. I set up a garden hose so its spraying a super fine jet into the side of the inside of my cloner lid causing a nice little wet fog to roll over the cuts. They are looking great still after about an hour.
Moral of the story. Don't panic and just figure it out!
Full cloner. 18 plants with only a week to go. I was already adding up how much it would set me back to re clone a new batch when an idea hit.
Idea number 1. Get a length of black tubing or whatever you got laying around hoselike and use it to massively blow air into your cloner Rez causing it to bubble furiously and in turn wetting your cuttings.
Idea 2. This is the one I implemented. I'm lucky enough to be on city water. I set up a garden hose so its spraying a super fine jet into the side of the inside of my cloner lid causing a nice little wet fog to roll over the cuts. They are looking great still after about an hour.
Moral of the story. Don't panic and just figure it out!