So in preparation for starting up again figured I'd get this going again.
Planned Improvements:
Building a screen to scrog. Bamboo skewers were a pain in the ass. The only advantage to skewers with lst is for sexing plants. On a screen would be difficult to pull out a male without screwing up some other plants.
Water irrigation needs some change.
When watering from the bottom, the perlite floats up between to the two totes causing some warping of the sides.
When using the pvc manifold it's impossible to get uniform coverage. One problem is clumping of soil and blockage of the holes, so I will be rotating the holes to leak out the side, but this will cause some permanent water storage in the manifold itself. I may also drill out a larger hole on each section in order to water faster. I previously would have to water in small quantities to keep it from backing up and overflowing out the inlet. I'm also considering the use of blumats instead.
I previously was counting on wicking of the perlite. I think some cloth or some such needs to be added to the bottom of the perlite container and up into the coco container to improve the wicking action. Not sure I'll personally add it here, but would recommend for a new setup, I'm just too lazy to add it now.
Since my chinese led died I've been shut down. I now have 2 CXA3070 leds running at 1.4 amps each for nearly 50w each. I'm putting these in my flower cab.