DS I agree with GG. 6 Onyx would be awesome but for now adding the dormgrow until you get more funds is a great idea. Also, if you have any HPS that could be a cheap way to get full coverage. I normally recommend against the Cree globes because they are only 89lm/W and omnidirectional. They introduce complexity into the grow space and if you are OK with complexity you could just as well go DIY COBs and get 125lm/W for about the same price.
Well guys thanks for you input, looks like for the time being I will be utilizing the four I have for one of my dorm grow lights the inner rows of lights and the outer row of leds still light up on that panel. I contacted them yesterday, no answer. I don't want to put any money into them so perhaps if I return it I can get some sort of partial refund, who knows except I am not spending another dime on Dorm Grow.
Anywise I these Onyx leds even with two panels on 4 plants should do me will and when I can get two more of them then I will place six under the set of lights.
I talked with Rapid Led they don't seem to think in another panel is needed in that space but only doing some growing under them will tell.
So I've got the room window cleaned repainted inside around the boarder then sealed it with panda film white facing out black to inside of room. This should help keep out heat from sun and conceal the light given off in that room from prying eyes.
Got the carpet tack strips up and staples out, doing a final sweep on floor today then shellac it, once dry I will lay down the panda film with a boarder running a foot up the walls so I can tack it to the walls using 1x2 board which I will be using to tack down the panda film I will run up the 3 existing walls. Then I will seal the seams between the pieces with silver HVAC tape and tack a 1x2's constructing a frame to keep panda film in place and to used as a platform to further construct while mounting additional equipment.Then I have to frame the final wall which I will divide the room and seal of the flowering room from the veg\clone area.
CO2 equipment is going cost me, any ideas where to get best deal on Titian controller monitor and tank and regulator?
My LG portable air conditioner is in place and currently venting out through the floor in 6 inch ducting, I need to re-route through ceiling into attic, don't really think its best to run under the house there but I made it originally thinking it would be my fresh air intake before I decided to go sealed.
Dehumidifier on the way in case this LG can't keep up.
Got to get to work on building out my passive hydroponic watering system, to essentially automate the flowering room. I will be hand watering in the veg room also have to setup the cloner in there. I am sure there will be some challenges in utilizing the remaining space to clone and veg enough girls to keep it perpetual.
Window sealed, wondering could this room be dual purpose as in a safe room in the event of a biological or chemical attack?
DankSwag