T5 to LED to HPS

Lennut

Well-Known Member
I am currently running an LED light in a 3x3 tent. I am setting up a 4 x 8 tent with two Gavita Pro 6/750 watt lights. My question is can I start seeds under a T5 light and veg with the LED and the flower with HPS. Will this work?
 

Nizza

Well-Known Member
all you have to do when changing light sources is acclimate the plant to that light

for example run 25% power 25% distance , next day 50% power 25% distance, then 50%/50%... slowly work towards max

you should do this when changing to any light source. The sun, HID (hps/mh) or LED.

I think flouro's need the least acclimation as they aren't an agressive light
 

Lennut

Well-Known Member
Yes, considerably IMO. I replaced a 400WMH & 2x600WHPS (2 cool tubes) setup with 3x315CMH (no cool tubes) and even with the ballasts inside the tent it's no warmer. Bulbs last longer too.
Sun System LEC Boss 315 Watt Commercial Fixture with 3,100K Lamp, 120 Volt In a 5 x 5 area?
 

Lennut

Well-Known Member
Yes, considerably IMO. I replaced a 400WMH & 2x600WHPS (2 cool tubes) setup with 3x315CMH (no cool tubes) and even with the ballasts inside the tent it's no warmer. Bulbs last longer too.
Jump Start Sunburst 315W CMH Grow Light Fixture
 

Lennut

Well-Known Member
What is the way to judge these lights?
I'm a LED guy from seed to finish..the pic of the canopy is at day 47 vegetative stage.. but yes you can go from one to the next if you know your light distances..
I like the LED too. My issue is cost of LED.
 
What is the way to judge these lights?

I like the LED too. My issue is cost of LED.
I never had a problem with cost when at $70-$240 for a light isn't bad been using same lights for over a year now... $70 light is 300watt full spectrum and the $200-240 is a 900 watt full spectrum.. currently I use 2 300 watt for flower... 1 300 watt for vegetative stage.. in a 3x3 tent both stages same size tents
 

Lennut

Well-Known Member
I never had a problem with cost when at $70-$240 for a light isn't bad been using same lights for over a year now... $70 light is 300watt full spectrum and the $200-240 is a 900 watt full spectrum.. currently I use 2 300 watt for flower... 1 300 watt for vegetative stage.. in a 3x3 tent both stages same size tents
I was basing off lights like Kind. I ain't to knowledgable about that stuff and would have to buy the light ready to use
 

Smokesteve

Well-Known Member
I never had a problem with cost when at $70-$240 for a light isn't bad been using same lights for over a year now... $70 light is 300watt full spectrum and the $200-240 is a 900 watt full spectrum.. currently I use 2 300 watt for flower... 1 300 watt for vegetative stage.. in a 3x3 tent both stages same size tents
With most LED lights those wattage numbers are wildly inaccurate.
 
Light ready to use of Amazon is viparspectrum comes in many lights but just do a search for led grow lights and choose a "viparspectrum" for brand...... distance from top of canopy during veg is 24-34 inches depending on age.. just watch your upward growth to fast is the light is too far away no more than 1/4 inch a day.. during flower for first two weeks I'd keep 2 300 watt led at 28-30 inches from top of canopy... only have to raise lights when canopy has grown 2-4 inchs closer(both stages) after the first two weeks of flower you can stop raising lights but not to let the canopy or top of buds get any closer than 18-20 inches...
 
With most LED lights those wattage numbers are wildly inaccurate.
Not in the sense I'm sure your trying to make... L.E.D.s use less wattage for draw of power.. L.E.D.s only use less power to create light.. with true full spectrum L.E.D. lights you get an even greater bandwidth of light spectrum as well..
 

Lennut

Well-Known Member
Not in the sense I'm sure your trying to make... L.E.D.s use less wattage for draw of power.. L.E.D.s only use less power to create light.. with true full spectrum L.E.D. lights you get an even greater bandwidth of light spectrum as well..
Not that I don't care about cost but..... I am more for the best light possible
 

Lennut

Well-Known Member
This is a hobby for me and just for fun. Its to prove I can do it and get some good smoke along the way
 

coreywebster

Well-Known Member
Not in the sense I'm sure your trying to make... L.E.D.s use less wattage for draw of power.. L.E.D.s only use less power to create light.. with true full spectrum L.E.D. lights you get an even greater bandwidth of light spectrum as well..
Exactly in the sense he is trying to suggest. You have a 300w light and a 900w light, neither of them draw the power stated in the title.
Misleading!
Why not call them what they are 130w light? Because that wouldn't sound as good.

300w light is a stretch of the truth unless it draws 300w.
Smoke and mirrors.
 

Colo MMJ

Well-Known Member
all you have to do when changing light sources is acclimate the plant to that light

for example run 25% power 25% distance , next day 50% power 25% distance, then 50%/50%... slowly work towards max

you should do this when changing to any light source. The sun, HID (hps/mh) or LED.

I think flouro's need the least acclimation as they aren't an agressive light
Babies and teens are perfect for T5's/T8s. I agree with you.
 
Exactly in the sense he is trying to suggest. You have a 300w light and a 900w light, neither of them draw the power stated in the title.
Misleading!
Why not call them what they are 130w light? Because that wouldn't sound as good.

300w light is a stretch of the truth unless it draws 300w.
Smoke and mirrors.
You obviously dont understand power from light.. your light say 300 watt hps/ms only produces 300 watts of light while consuming 300 watts electricity while my say 300 watt full spectrum led produces 300 watts of light while only consuming 130 watts +/- 3%.. just because led use less electricity to produce light doesn't make it smoke and mirrors lmao...
 
Top