Is the environment on point for LEDs?
This is the part I am ignorant to.
I may or may not be dialed in.
Please let me know.
Plants are in veg
The light is a 600 R spec HLG currently about 48 inches above the plants and that is temporary because they are sick. I didn’t want them to be super close. It’s at 40% power right now.
Humidity is at 45%
Temps are between 70-75, there is an air conditioner inside my tent to save space because of my living situation
CO2 on a very low setting, I don’t have an environmental controller to test the levels, but it kicks on every two hours for 15 minutes at .5 setting on my tank. I’m leaving it like that for right now just because I don’t have the environmental controller.
Fan above canopy
fresh air being pushed in throughout the day to swap it all out
I might switch over to Coco here soon
Just because the water situation out here is ridiculous
I calibrated my pen, even bought a new one, just to make sure, and the ph was 8.6-8.7 ppms at 500 out of the tap. I filter the water for chlorine, Chloramine and sediment. But because it fluctuates so much if I’m not checking the water and adjusting it every single time, I lose.
Open to any advice or suggestions
I love learning new things