The Hempy Collective

Status
Not open for further replies.

Damion5050

Well-Known Member
Check this out get it just for the hexk of it it's cheap and it's 400 watts unless power consumption is an issue a 150 watt system puts out about 16,000 lumens, this with the good bulb puts out 55,000 lumens.. And the extra bulb is only 40 bucks so you would spend about 140 bucks total plus shipping for 55K lumens...

High Tech Garden Supply

Or you can go with the cheap bulb knock 40 off the cost so 100 bucks plus like 20 shipping and you got about 49K lumens
 

Azgrow

Well-Known Member
for hid lighting rule of thumb is 42watts per sq foot for good plant an bud growth...for cfls it goes by lumens per sqfoot....as for hempy sog that excatly what i do now.....rinse the per-lite for dust control only imo.....peace az
 

bigd921

Well-Known Member
Check this out get it just for the hexk of it it's cheap and it's 400 watts unless power consumption is an issue a 150 watt system puts out about 16,000 lumens, this with the good bulb puts out 55,000 lumens.. And the extra bulb is only 40 bucks so you would spend about 140 bucks total plus shipping for 55K lumens...

High Tech Garden Supply

Or you can go with the cheap bulb knock 40 off the cost so 100 bucks plus like 20 shipping and you got about 49K lumens
my issue isnt power consumption I would love to go 400w even 1000w but with the size of my space HEAT is my concearn I have a hard time keeping it under 85 with the cfls, I may do some minor remodeling and go with a 4ft 4bulb h/o t5 from htg its 20k lumens and 200 some odd watts, I can do some sawing andmake my closet wider, the wife wont mind that as much as me cutting holes in the ceiling to vent heat lol, I am hoping I can get 10 plants under that without a problem what do you guys think??
 

Damion5050

Well-Known Member
A 3x3 with 10 plants and only 150 watts is not enough u need to get a 250 watt system thats what I am a 250watt HPS.. My flowering area is 3x2x6 foot tall and I am using a nice vent fan that wasn't too much it moves like 340 cfm.. You should use the same vent fan or something similar it would displace the air in your closet in about 60 seconds..

That means it would take all the old air out and pump fresh air into the room in 60 seconds... What you could do is buy a cheap thermostat control and hook it up to the fan so the fan turns on when it hits say 82 degrees and shuts off when it hits 78 degress... Or something along those lines..
 

bigd921

Well-Known Member
A 3x3 with 10 plants and only 150 watts is not enough u need to get a 250 watt system thats what I am a 250watt HPS.. My flowering area is 3x2x6 foot tall and I am using a nice vent fan that wasn't too much it moves like 340 cfm.. You should use the same vent fan or something similar it would displace the air in your closet in about 60 seconds..

That means it would take all the old air out and pump fresh air into the room in 60 seconds... What you could do is buy a cheap thermostat control and hook it up to the fan so the fan turns on when it hits say 82 degrees and shuts off when it hits 78 degress... Or something along those lines..
do you have pics of your setup in your journal?? I want to maximize my true hempy potential :hump:
 

Damion5050

Well-Known Member
You can look at my journal and see the pics I have in there currently.. But I just received my new vent fan yesterday and I am waiting on mylar to come.. I am in no hurry cause my plants are only on like day 7 of veg so I have time ti finish my setup..
 

Damion5050

Well-Known Member
I am also waiting on my Clone Box I ordered from HomeGrowBox to come it is gona be my new mothering and vegging area.. It's gona be fucking sweet I got 2 20k lumen T5's coming for it as well :mrgreen:
 

cirrus12

Well-Known Member
for hid lighting rule of thumb is 42watts per sq foot for good plant an bud growth...for cfls it goes by lumens per sqfoot....as for hempy sog that excatly what i do now.....rinse the per-lite for dust control only imo.....peace az
I'm using a grow tent that gives me 2 sq feet of grow space. I have a T5 hood that has 2 55watt tubes, total of 10,000 lumens. This enough?
 

jc83

Well-Known Member
This hempy thread is great,,ive got 5 plants growing hemp style in 10lt buckets under a 600w hps. I was overfeeding at first but now they are really looking good. My run off water is ph 6.0- 6.4 do you guys reckon this is a ok range?
 

Azgrow

Well-Known Member
thats were i keep mine with no problems as far as ph....if im not mistaken when going be lumens you want like 10-20k per sq foot....you cfls guys can step in an correct me if im mistaken.....peace az
 

jc83

Well-Known Member
AZ when you say you water twice and then heavy feed, does that mean i should mix my nute solution full stength as the directions say? Thanks.
 

Azgrow

Well-Known Member
what age are the plants...an what kind lighting....what kind of nutes an what is the n-p-k.....if using hid an running nutes like ff or an or gh...an the plants are 4weeks+old...then yes water water use nutes at full strength water water light feed water water full strength etc etc...peace az
 

Azgrow

Well-Known Member
well it seems you found my hempy collective...this is where the hempy growers of riu are able to come an insight each other with grows an information that they have learned so we may all learn together...feel free to light one up an enjoy the show..an please if any questions you might have pop up....please ask...peace az
 

jc83

Well-Known Member
what age are the plants...an what kind lighting....what kind of nutes an what is the n-p-k.....if using hid an running nutes like ff or an or gh...an the plants are 4weeks+old...then yes water water use nutes at full strength water water light feed water water full strength etc etc...peace az
Im using 2 part hydro nutes .one bottle is 2.8-0-6.0 the other 2.0-1-1.2. The plants are 4 weeks old under 600w HPS. I think ill just go 3/4 strength for the heavy feed and see how it goes.
 

HazyEyes

Well-Known Member
what age are the plants...an what kind lighting....what kind of nutes an what is the n-p-k.....if using hid an running nutes like ff or an or gh...an the plants are 4weeks+old...then yes water water use nutes at full strength water water light feed water water full strength etc etc...peace az
Wont the full strng burn the fuck out of the plants if they are not ready for it??
 

Azgrow

Well-Known Member
thats why i asked what all his conditions are....npk lights plantage....an looking by the age an npk value of those nutes an light he's using....i assume those plants will be able to handle the full strength by the forth week of veg i am normally full dose feeding an some strains like fadeds raft get fed at 150% cause they are nute hungry....but like my ogk an dogcut dont like nutes much so we keep her fed light....start with the 3/4 but if you start noticing a n def. make sure to up it to full dose...peace az
 

jc83

Well-Known Member
Im going to buy some canna nutes for my hempy plants they are in 100% perlite. If anyone else is using canna can you tell me if I should be using the aqua or subtra line?CANNA-AU.com - Products Thanks.
 
Status
Not open for further replies.
Top