Search results

If you tried the dirt and it didn't work try a cup of water. Literally a cup filled with water and put them in there. That's what I do and all mine pop

How far away is the light? I have mine almost on top of the canopy no bleaching or heat stress. They're on week 4 now will post harvest when ready

what kind of water you using?

I'm not seeing calcium looks more like ph issue overall. But if you're in hydro keep it 5.8-6.1. What nutes and ec/ppm?

Overdrive is for last 2 weeks of flowering to pump more trichomes/swell the buds up. Using it earlier will do more harm. You have yellowing in the veins. Looks like calcium. With an hlg 550 that's most likely the problem. and get that light closer 34" is too far. I've had mine about 18"

if you're in soil feeding ph of 5.7-6.2 that's your problem. feed ph of 6.3-6.8. I do 6.5-6.6

Well you don't want stress at all it's never good but they're your plants. Get them transplanted before they hit 2ft

I use a flood table to veg everything and transplant whatever number of plants to each light(s) available

ya you'll be fine. I use an aero cloner for all clones and have gone to soil, coco, hydroton with no problems. Don't let the root mass get too big though or they can get stressed

ya it's mold. most likely bud rot so peel the bud apart a little and see how bad it is. If not too bad try to finish it out with more fans on them and cut the mold off. Your fans should be blowing at the canopy not under

These clones have been on the table 2 weeks now. I put them under a hlg 550 rspec, thought it would be better than a 600hps. The clones are beautiful but they're taking longer than I want for them to start properly vegging. Will a 600MH or even the hps help speed it up?

Best bet is find the mold and cut it out if you can. Possibly will still spread but try to get your humidity down and more fans on them. I wouldn't chop yet to stop it those still have 3-4 weeks

If you're currently flushing then that's why your leaves are changing. Don't "flush" just lower the feeding. The nanners could be genetics but most likely stress from the environment or feeding

you can put a 400 hps about 12 inches. It's not super powerful the plants will stretch if it's too far

I'm battling this problem now. New strain that's super dense and apparently doesn't like humidity at 60 percent. I have a 6inch inline and a fan blowing air and I'm still getting some mold/bud rot. Is it going to spread or if I control the humidity now will it stop?

I bought 2 of the e-720. I didn't get the controller. Mine came perfectly boxed and were brand new from what I inspected. Don't have a par meter so can't tell you the par reading but are both you lights running on same voltage?

I would be worried if they're gonna bud before stretching with that much leaf gone

Get the temp down or you're wasting your time. They're not going to fatten up much more with temps that high

The hps/cmh would be better with 2 lights for better coverage and different spectrums

I lost almost every clone in my cloner when temps were too warm. Put the temps into 70's and didn't lose any since