Help! Leaves curling

2andfly said:
Temp on the gauge say 20.7c right now but i have it open trying to do my set up thanks bro...and it’s sister* :wink:
Click to expand...
ok mom ur temps are 20c so if you up to about 28c ur humidity will drop to about 60% hopefully

sister :) u need a good avy like mine
 
2andfly said:
Sorry what I’m asking is does the fan blow into the carbon filter? Tryna figure out the correct way to put my fan. Suction is out?
Click to expand...
You want the carbon on the suction side of the fan
2andfly said:
Al

also once i install How long should i wait To switch to flowering?
Click to expand...
That would be up to you personally on when to flower. Get your environment in check first. I would put the filter on the suction side of the fan, so the air is pulled into the filter then out the fan and finally exhausted.
 
budofgreen said:
You want the carbon on the suction side of the fan

That would be up to you personally on when to flower. Get your environment in check first. I would put the filter on the suction side of the fan, so the air is pulled into the filter then out the fan and finally exhausted.
Click to expand...
Thanks bro you’ve been a ton of help, preciate it a lot !
 
here is my second grow..... the tall one is Grease Monkey.... I have a net in there but, it isn't even like it should be..... Grease Monkey is topped so it has two main colas!!! Woot!
 

Attachments

  • 130095095_422944205399853_1080562483282443854_n.jpg
    130095095_422944205399853_1080562483282443854_n.jpg
    356.5 KB · Views: 22
budofgreen said:
Your welcome. Just read up on exhaust setups and find one that works for your situation. Your plant doesn't look bad either. Good luck!
Click to expand...
Should i run the duct outside the tent and switch the set up? Idk bout the suction
 

Attachments

  • image.jpg
    image.jpg
    757.2 KB · Views: 5
2andfly said:
Went with this set up, got the fan on the lowest setting
Click to expand...
That will be a game changer. Keep an eye on your temp/humidity and keep them in ballpark range and you should be good. If your tent bows in too much open up an air flap at the bottom for some passive intake to the tent. Just keep reading on the subject matter, some of it is just preference. Keep it simple.
 
budofgreen said:
That will be a game changer. Keep an eye on your temp/humidity and keep them in ballpark range and you should be good. If your tent bows in too much open up an air flap at the bottom for some passive intake to the tent. Just keep reading on the subject matter, some of it is just preference. Keep it simple.
Click to expand...
image.jpg
 
budofgreen said:
Well now you are learning some high stress training...:clap:
Click to expand...
shit hurt my heart..do i leave One of these open to reduce suction a little? And if humidity is at 44% do i need To put a humidifier in? Or give it time ? Last couple questions and I’ll leave u alone image.jpg
 
I would take some of the 4" flex duct you have, and put it through the port you show in the picture above, and make it into a U, so no light gets in/out of your tent.

If your humidity is still a little too low, you can add some tape over half of your exhaust duct to reduce the airflow rate even more. I do that in my drying room to reduce airflow and extend my drying time.
 
You must log in or register to reply here.
Back
Top