What did you accomplish today?

Aeroknow

Well-Known Member
I've seen some hotties in Home Depot in Lincoln, same with Lowes, not sure if they were up for some slap and tickle.
I’ve been thinking I need to hang out at or near the hospitals. Nurses make the best companions plus they make bank :-)

or, i could pretend to be a chreeeeestian for a second and go to church for a minute. Prob meet a good chick there. And then surprise! I’m not down with jesus anymore lmao
 

RetiredToker76

Well-Known Member
Yesterday I installed the firmware update in my Mazda to 70.0.0.335. Today I took apart the dash and center console and installed the media unit with the USB that's compatible with Carplay, four hours later and I got it working and didn't have any parts left over other than the communications hub I replaced.

IMG_8949.HEIC.jpeg
 

Blue Wizard

Well-Known Member
Have you considered running Linux on it?
I completely wipe everything off, and installed windows 10 again. It took all damn day to do it lol.

It had to repair the C: drive apparently and I don't know what the deal was but windows looks way different now than it did. It's supposedly the same version I was running too, I have no idea.

I just know it's actually running and not freezing up for several minutes at a time like it was.
 

TerryTeacosy

Well-Known Member
Achieved SFA today - 39C yesterday (worked on the house build from 6am until after 1pm & then pulled the pin).

Overnight low of 25C & fuck-all sleep.

37C today & decided that discretion was the better part of valour, precariously balanced on top of a 12' ladder & cramping.
Current temperature on the slab is 48C.

With age comes wisdom......& an excuse to drink beer instead:)

That said, I do have a CBN-heavy project in mind with some years-old gear I completely forgot I had stashed-away in what the Mrs calls "The Naughty-Corner"
DSCN3126.JPG
 
Last edited:

DarkWeb

Well-Known Member
I tried to replace the EVAP pump on the truck, it is still throwing a code. I did everything I could think of the disconnect the connector on it and I can't budge it. I guess it's going to the shop to do a 10 minute job.
Did the computer reset? Just like clearing a code or disconnecting the battery. Run it for a few days.
 

DarkWeb

Well-Known Member
Yes, I reset it with my scanner. They found no leaks and said it might be the pump, which is why I tried to replace it.
It might take some time to have everything sync up again. I had a jeep that I put a battery disconnect in and every time I went to get it inspected I'd have to drive it about 150 miles for everything to work together again so the inspection scanned correct. If you plug your scanner back in.....does it say "not ready" for anything?
 

raratt

Well-Known Member
It might take some time to have everything sync up again. I had a jeep that I put a battery disconnect in and every time I went to get it inspected I'd have to drive it about 150 miles for everything to work together again so the inspection scanned correct. If you plug your scanner back in.....does it say "not ready" for anything?
It shows a code after setting the sensors.
 
Top