Hashishh's Perpetual Fishing Trip
- Thread starter Hashishh
- Start date
Hashishh
Well-Known Member
Waiting on clones to reveg. Have buckets prepped and ready to go. I figure another 3-4 weeks and I'll transplant. Once the 4x4 is done clones should be established enough for flower. Worst comes to worst I have another 4x4 and HPS I can put them under if they get ahead of the flower tent.
So far going outdoors I have;
- 3x Bubba Kush
- 2x Nuken Bag Seed
- 1x Copper Chem Male
Going to pop some Widow and Early Miss autos. They're old seeds so I'm not expecting much.
So far going outdoors I have;
- 3x Bubba Kush
- 2x Nuken Bag Seed
- 1x Copper Chem Male
Going to pop some Widow and Early Miss autos. They're old seeds so I'm not expecting much.
Hashishh
Well-Known Member
Been busy busy lately.
Got the Sundae Stallion down. Low yield, but pretty and potent looking plant. Was about a week early (went approx 11 weeks total) but I had to make room in the tent. Overall not very impressed. Won't bother running this one again.
I do have about a hundred seeds from the Sundae Stallion x Copper Chem cross if I ever want to revisit the strain again.
Copper Chem has another week or so to go which will bring it to about 13 weeks total since flip.
I ordered some new lights so it's possible I'll be getting both 4x4's and a breeding tent going for the winter like I planned.
With the price of lumber however, Reno's are currently on hold so I won't be getting the room I wanted but I have a few upgrades and additions coming as soon as snail mail can get them in.
Got the Sundae Stallion down. Low yield, but pretty and potent looking plant. Was about a week early (went approx 11 weeks total) but I had to make room in the tent. Overall not very impressed. Won't bother running this one again.
I do have about a hundred seeds from the Sundae Stallion x Copper Chem cross if I ever want to revisit the strain again.
Copper Chem has another week or so to go which will bring it to about 13 weeks total since flip.
I ordered some new lights so it's possible I'll be getting both 4x4's and a breeding tent going for the winter like I planned.
With the price of lumber however, Reno's are currently on hold so I won't be getting the room I wanted but I have a few upgrades and additions coming as soon as snail mail can get them in.
Hashishh
Well-Known Member
Chopped some of the Copper Chem, just shy of week 13. Going to let some of the lowers get some light before giving her the scissors again.
Buds are fairly large, and extremely dense. Not quite as sticky as the Sundae Stallion, but twice as large and dense. Way easier to trim as well. If the potency checks out then this will be a regular in my rotation.
Buds are fairly large, and extremely dense. Not quite as sticky as the Sundae Stallion, but twice as large and dense. Way easier to trim as well. If the potency checks out then this will be a regular in my rotation.
Hashishh
Well-Known Member
Currently trying to find a spot for the additional 4x4 and to move the current 4x4 going.
There's going to be some pretty cool changes and additions this week and next in preparation for winter.
- Adding another 4x4 tent.
- Meijiu QB 288 is going to be replacing my current T8 in the 2x4 veg tent.
- Meijiu 600w Bar LED being added.
The T8 is going to be repurposed to use for propagation in a seperate area. Mostly to test and germinate seeds, root clones, possibly keep a mother or 2.
QB 288 is going to be used in the 2x4 veg area. This is where I'll be vegging my rooted cuttings after they've been selected. 3-6 cuttings every 3-4 weeks.
Meijiu 600w A8 is going in the first 4x4 as my main flower light and I'll keep running the HPS in the "test tent".
My plan is to use the test tent to run new seed batches and some light breeding.
On a seperate note - I've got a few hundred seeds from the first Sundae Stallion (Sundae Stallion x Copper Chem). And it seems another few hundred from the Copper Chem x Copper Chem.
I sprouted some Bangi Haze and Erdpurt by Ace Seeds, all came up. I'm going to run the females in the test tent and select a few Erdpurt males to place outside for selection. If I can find a keeper I have some short flower crosses I'd like to experiment with in our cold climate.
There's going to be some pretty cool changes and additions this week and next in preparation for winter.
- Adding another 4x4 tent.
- Meijiu QB 288 is going to be replacing my current T8 in the 2x4 veg tent.
- Meijiu 600w Bar LED being added.
The T8 is going to be repurposed to use for propagation in a seperate area. Mostly to test and germinate seeds, root clones, possibly keep a mother or 2.
QB 288 is going to be used in the 2x4 veg area. This is where I'll be vegging my rooted cuttings after they've been selected. 3-6 cuttings every 3-4 weeks.
Meijiu 600w A8 is going in the first 4x4 as my main flower light and I'll keep running the HPS in the "test tent".
My plan is to use the test tent to run new seed batches and some light breeding.
On a seperate note - I've got a few hundred seeds from the first Sundae Stallion (Sundae Stallion x Copper Chem). And it seems another few hundred from the Copper Chem x Copper Chem.
I sprouted some Bangi Haze and Erdpurt by Ace Seeds, all came up. I'm going to run the females in the test tent and select a few Erdpurt males to place outside for selection. If I can find a keeper I have some short flower crosses I'd like to experiment with in our cold climate.
Hashishh
Well-Known Member
Chop, chop, chop.
Got the tops down for last pheno. Long buds, but skinny and quite fluffy. I feel like the plant went a bit longer than it should have and temps were fairly high which caused the buds to fluff up a bit.
Regardless I'm still looking at about 3oz of prime buds off that plant as well. Decent yielder, just not the density and quality I wanted out of it.
So out of 3 I got 1 definite keeper which isn't bad at all.
I'm going to run pheno 1 again and if it proves itself once more I'll have to get some CS and do an S1.
Still no smoke reports other than the SS which I've been puffing on for a few days now. I figure a few more days and I can pull a few small testers to try out.
The SS has a few more days of hanging before going into jars but I've got to say I'm quite impressed.
Got the tops down for last pheno. Long buds, but skinny and quite fluffy. I feel like the plant went a bit longer than it should have and temps were fairly high which caused the buds to fluff up a bit.
Regardless I'm still looking at about 3oz of prime buds off that plant as well. Decent yielder, just not the density and quality I wanted out of it.
So out of 3 I got 1 definite keeper which isn't bad at all.
I'm going to run pheno 1 again and if it proves itself once more I'll have to get some CS and do an S1.
Still no smoke reports other than the SS which I've been puffing on for a few days now. I figure a few more days and I can pull a few small testers to try out.
The SS has a few more days of hanging before going into jars but I've got to say I'm quite impressed.
Hashishh
Well-Known Member
On another note got both 4x4's hooked up and the 2x4.
My Meijiu lights should be in early next week, so I'll get both 4x4's fired up within the next 2 weeks. Really excited to try these new bar LEDs, especially coming from an HID background.
3 weeks left to reveg I figure before these Copper Chems hit the flower tent. 6x Ace Seeds Erdpurt and 2x Ace Seeds Bangi Haze.
The Bangi are gonna get run under 600w of HPS along with the Copper Chem. The Erdpurt are gonna get sexed and run under the LED. I'm hoping to find a mom among the EP that doesn't autoflower.
My Meijiu lights should be in early next week, so I'll get both 4x4's fired up within the next 2 weeks. Really excited to try these new bar LEDs, especially coming from an HID background.
3 weeks left to reveg I figure before these Copper Chems hit the flower tent. 6x Ace Seeds Erdpurt and 2x Ace Seeds Bangi Haze.
The Bangi are gonna get run under 600w of HPS along with the Copper Chem. The Erdpurt are gonna get sexed and run under the LED. I'm hoping to find a mom among the EP that doesn't autoflower.
Hashishh
Well-Known Member
Had a change of plans.
After chopping down the Copper Chem and trying it I found the high really lacking. I've given the larger buds a longer dry and I'll see how it does after a lengthy cure but I'm really not all that hopeful.
Tastes great, smells amazing, but really doesn't check the boxes for me. I'm thinking I chopped a bit early.
Finally got my QB in for the veg tent so I'm starting to get things dialed in now. What a difference going to LED.
Another week or two and I'll take a few clones off the Erdpurt and start staggering my harvests.
I haven't had much time for the ladies lately so I messed up some feeds. I'm revegging some of the CC4 to see how monster cropping goes since they're showing some deficiencies and I'd rather have them healthy before finishing them up.
Right now my main focus is going to be on the Erdpurt. Have been vegging quite well since I tossed the QB in.
Copper Chem #4 pheno in buckets, Erdpurt in 1 gallon pots and a couple Bangi Haze in solos just for fun.
Going to try out the Ace gear and see how it goes. At this point I'm looking for a good yielding indica with a fair amount of CBD.
After chopping down the Copper Chem and trying it I found the high really lacking. I've given the larger buds a longer dry and I'll see how it does after a lengthy cure but I'm really not all that hopeful.
Tastes great, smells amazing, but really doesn't check the boxes for me. I'm thinking I chopped a bit early.
Finally got my QB in for the veg tent so I'm starting to get things dialed in now. What a difference going to LED.
Another week or two and I'll take a few clones off the Erdpurt and start staggering my harvests.
I haven't had much time for the ladies lately so I messed up some feeds. I'm revegging some of the CC4 to see how monster cropping goes since they're showing some deficiencies and I'd rather have them healthy before finishing them up.
Right now my main focus is going to be on the Erdpurt. Have been vegging quite well since I tossed the QB in.
Copper Chem #4 pheno in buckets, Erdpurt in 1 gallon pots and a couple Bangi Haze in solos just for fun.
Going to try out the Ace gear and see how it goes. At this point I'm looking for a good yielding indica with a fair amount of CBD.
Hashishh
Well-Known Member
Ah man, I miss the lake!I don't mind sharing a few of my finer moments lol...
View attachment 4937257View attachment 4937258View attachment 4937259
We've had some rain and its to continue into next week so I'm optimistic about a salmon or two this weekdelighted!
I haven't even had a chance to set up the camper or boat this year.
We've had a new addition to the family so time has been slim between work and everything else.
The wife gave me the go-ahead for a week out during labour day so next week I got to get the boat ready.
If Im feeling energetic I'll take the boat out for a spin and see if I can smash a few Lakers.
Feel free to post away anyone, at least I can live vicariously through you guys!
bam0813
Well-Known Member
Hell with trout,those walleye are the finest table fare that comes out of fresh water imo
bam0813
Well-Known Member
I tried once but they never stay litNice looking plants.
You ever smoke the trout? That's some good eating friend.
Hashishh
Well-Known Member
I find them bland myself, but I've never turned down a fish fry!
I like em deep fried in flour, cornmeal and cajun or lemon pepper
I just got a new meat grinder for fathers day so I see pike burgers on the horizon
Hashishh
Well-Known Member
Thanks for stopping by! Feel free to post some pics of some fish and fries!
Hell I'll even take an invite for dinner!
