Search results

looks like you have a consensus already.

13 thousand amps??? are you in N.America? Europe has different power system. in US, most surge protectors plug into the outlet, then you plug anything you want to protect into the surge protector

you in N America? it matters dont have time now to look up the tables but 2AWG...................... = 2 gauge wire 600v ........................ = rated for up to 600 volts T90 NYLON............= Type of coating on wire THWN-2 or THHN = type of wire if hot wire is copper...

mommy wont let you grow so you hide it from her? that sounds like something a weasel or a child would do.

depends,are you in a tiny studio apartment? it will. if your in a 5 bedroom 3000 sq ft house, then no. rule of thumb is 1000watts of light per bedroom is no problem.

I dont do hydro but you want your water adjusted to the proper PH level befor it gets to your plants.

I dont do hydro so I cant comment on the bubble bucket but I have started clones and seeds in rockwool & can say that you dont want the rockwool to dry out.

MG is loaded w/ chemical ferts so for the first 3 months or so, be very careful about adding anything, especially chemical ferts. I use organic MG and while I use some chemical ferts, I go very lightly w/ them and rely on organics as much as possible. local big box stores carry alot of organic...

HPS lights throw an oblong light pattern w/ less light coming from the ends so mount it horizontally w/ the base at the back or front and the sides facing the longer area. since you are only planning 3 plants& only have 5 feet of height, you probably wont use all 4 feet wide.I would consider a...

with a good carbon filter, you should be fine.if you are really worried,go ahead & vent into another room. venting into the same room w/ a 600 watt light will lead to overheating

to start,shame on you for growing behind her back! that shows a lot of disrespect for your mother. she's ok w/ it now so you better kiss her ass to thank her (best way to do that is to grow up & stop doing stupid kid shit) next, find your state laws & make sure you stay small enough so you don't...

are you using the entire closet for veg? a 150 watt hps or mh will be ok for 24x24 area to start but will not be enough once the plants get much over a foot high.

if you are exausting the cab into the closet, nothing will work unless you vent the closet as well

how many lights? if its large enough, it may work but if your only running 1k in lights, the heat signature is a joke and you are wasting your time.if your running 6-8 1k lights,it might work but you would need a long run & a large pipe,(1-2 feet) and leave the far end open so the air has a...

read it again you only need the extras if you want data logging, remote use,ect. out of the box, it will give you a low current short to ground when CO2 levels reach 1000ppm and open when levels drop below 800. a low current draw relay and a power supply is all you need to give a signal to your...

pulling is more effective but it creates a vacum inside the light fixture and ducting that could pull in smells,pushing will create pressure blowing air out any leaks in the ducting & fixtures

am considering a sealed room next yr and found this in my research, a co2 meter w/ output that could be set up w/ a relay to control CO2 for under $100.( I have seen it for $70 b4 but can't find that site http://www.co2meter.com/collections/co2-sensors/products/k-22-oc-co2-sensor-module it is...

yes, you need the ballast. also need a reflector and a mogel socket and a some wire to attach the light to the socket and a male plug.depending on where you plan to place it, a metal can (w/ vent holes)to mount it in would be a good idea. general rule of thumb is to expect 1/2 to 1 gram per watt...

my cheapest guess is that it could be a loose wire (or loose bulb) so open it up & check for a loose connection. >>> be careful!!! -even after being unplugged, the capacitor will hold voltage like a battery! enough to bite! for weeks. next guess would be the capacitor & since that is the...

they make holesaws that big but they are pricey &you also need a heavy duty drill so my advice would be to follow the above advice